STARTER (for Sedan for Cold Area Specification Vehicles) > REASSEMBLY



1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY


    A124187E01
  1. Apply grease to the drive lever set pin which is in contact with the starter pivot part of the drive lever set pin.



    A084665E03
  1. Install the drive lever set pin into the starter center bearing clutch sub-assembly.



    A083805E01
  1. Install the starter center bearing clutch sub-assembly together with the starter drive lever set pin into the starter drive housing assembly.



2. INSTALL STARTER PLANETARY GEAR


A082690E03
  1. Apply grease to the planetary gears and pin parts of the planetary shaft.

  1. Install the 3 planetary gears.



3. INSTALL STARTER ARMATURE ASSEMBLY


A073993E04
  1. Apply grease to the washer plate and the armature shaft.

  1. Install the armature shaft onto the starter commutator end frame assembly.

  1. Using snap ring pliers, install the plate washer and a new snap ring.



    A058810E01
  1. Using vernier calipers, measure the snap ring.

    Maximum length:
    5.0 mm (0.197 in.)
    If the length is greater than the maximum, replace the snap ring.


4. INSTALL STARTER COMMUTATOR END FRAME COVER


A084616E02
  1. Install the starter commutator end frame cover onto the starter commutator end frame assembly.



5. INSTALL STARTER ARMATURE PLATE


A073991E15
  1. Insert the starter armature plate into the starter yoke assembly.

  1. Align the cutout of the plate with the inside protrusion of the starter yoke assembly, and install the plate.



6. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY


A058587E01
  1. Align the starter commutator rubber end frame with the cutout of the starter yoke assembly.

  1. Install the starter yoke assembly onto the starter commutator end frame assembly.



7. INSTALL STARTER YOKE ASSEMBLY


A082693E01
  1. Align the key located on the starter yoke assembly with the keyway of the starter drive housing assembly.



    A082689E01
  1. Install the starter yoke assembly with the 2 through bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


8. INSTALL MAGNET SWITCH BODY


A082694E01
  1. Apply grease to the plunger and the hook.

  1. Put the plunger hook of the magnet switch body on the starter drive lever set pin.

  1. Install the plunger and the return spring as shown in the illustration.



    A082688E01
  1. Install the magnet switch body with the 2 screws.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }


    A081590E02
  1. Connect the lead wire to the terminal C with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7.4 ft.*lbf }