REAR SPEED SENSOR (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE REAR WHEEL


3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
  1. Release the parking brake and remove the rear brake drum.
    If the rear brake drum cannot be removed easily, perform the following procedure.



    F046068E02
  1. Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.

  1. Using another screwdriver, contract the brake shoe by turning the adjusting bolt.



4. DISCONNECT SKID CONTROL SENSOR WIRE


C125279
  1. Using a screwdriver, remove the claw of the connector lock portion and disconnect the skid control sensor wire connector.

    NOTICE:
    Do not remove the connector cover from the connector because the skid control sensor wire may be damaged.


5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


C121821
  1. Remove the 4 bolts and remove the axle hub and bearing from the axle beam.

    NOTICE:
    Suspend the backing plate with a piece of rope.