CENTER AIRBAG SENSOR ASSEMBLY (for Sedan) > REMOVAL


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).


1. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER


B132316

  1. Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.



2. REMOVE INSTRUMENT PANEL FINISH PANEL END LH


B132317

  1. Disengage the 6 claws and 3 clips and remove the instrument panel finish panel end LH.



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


    B132387

  1. Remove the shift lever knob.



4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B132347

  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and the claw and remove the upper console panel.



5. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B132348

  1. Disengage the 3 clips and 3 claws.

  1. Disconnect the connector and remove the console upper rear panel.



6. REMOVE CONSOLE BOX CARPET


B132346

  1. Remove the console box carpet.



7. REMOVE REAR CONSOLE BOX ASSEMBLY


    B132349

  1. Disconnect the clamp.

  1. Remove the 2 bolts and 2 screws.

  1. Disengage the 4 claws and remove the rear console box.



8. REMOVE INSTRUMENT PAD LOWER LH


B132339

  1. Remove screw <I>.

  1. Disengage the claw and 3 clips and remove the instrument panel pad lower.



9. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


B106565E01

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. Pull the lever down and detach the connector holder.



    B106566

  1. Remove the 3 bolts and remove the airbag sensor.