POWER STEERING ECU (for 1UR-FE) > REMOVAL |
for Preparation Click here
1. PRECAUTION |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. REMOVE FRONT DOOR SCUFF PLATE LH |
Detach the 6 claws and 3 clips, and remove the front door scuff plate.
4. REMOVE COWL SIDE TRIM BOARD LH |
Remove the clip.
Detach the 2 clips and remove the cowl side trim board.
5. REMOVE INSTRUMENT SIDE PANEL LH |
Using a moulding remover, detach the 7 claws and remove the side panel.
6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
Remove the hood lock control lever.
Remove the 2 bolts.
Detach the 9 clips and claw.
for Automatic Air Conditioning System:
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY |
Remove the 4 bolts and remove the instrument panel airbag.
Detach the 2 claws and disconnect the DLC3.
Disconnect the connector.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
8. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
Disconnect the connector and detach the wire harness clamp.
Detach the 12 clips and remove the finish panel.
9. REMOVE POWER STEERING ECU ASSEMBLY |
Disconnect the power steering ECU connector.
Remove the nut and power steering ECU.