CIRCUIT OPENING RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE CIRCUIT OPENING RELAY (C/OPN)

  1. Remove the circuit opening relay from the engine room relay block.



2. INSPECT CIRCUIT OPENING RELAY


    A111813E07

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    3 - 5
    		When no battery voltage is applied to terminals 1 and 2
    		10 kΩ or higher
    When battery voltage is applied to terminals 1 and 2
    		Below 1 Ω
    If the result is not as specified, replace the relay.


3. INSTALL CIRCUIT OPENING RELAY