EXHAUST PIPE (for Regular Cab Standard Deck) > REMOVAL |
for Preparation Click here
- CAUTION:
- Wear protective gloves when removing the exhaust pipe.
- The exhaust pipe is extremely hot immediately after the engine has stopped.
- Confirm that the exhaust pipe has cooled down before removing it.
1. REMOVE TAILPIPE ASSEMBLY |
Remove the bolt, clamp and gasket.
Disconnect the tailpipe from the exhaust pipe support.
2. REMOVE CENTER EXHAUST PIPE ASSEMBLY |
Remove the 4 bolts.
Disconnect the center exhaust pipe from the 3 exhaust pipe supports.
Remove the center exhaust pipe from the front exhaust pipe and front No. 3 exhaust pipe.
Remove the 2 gaskets from the front exhaust pipe.
3. REMOVE PROPELLER SHAFT HEAT INSULATOR |
Remove the 2 bolts and heat insulator.
4. REMOVE FRONT PROPELLER SHAFT ASSEMBLY |
for Front Differential Side:
Place matchmarks on the differential and propeller shaft flange.
Remove the 4 nuts, 4 washers and disconnect the propeller shaft from the differential.
- NOTICE:
- Use a rope to suspend the front edge of the propeller shaft.
for Transfer Side:
Place matchmarks on the transfer and propeller shaft flanges.
Remove the 4 nuts and 4 washers.
Remove the propeller shaft from the transfer flange.
5. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY |
Remove the 2 bolts and 2 nuts.
Disconnect the front No. 3 exhaust pipe from the exhaust pipe support.
Remove the front No. 3 exhaust pipe from the front No. 2 exhaust pipe.
6. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY |
Disconnect the air fuel ratio sensor connector.
Disconnect the heated oxygen sensor connector.
Remove the 3 nuts, front No. 2 exhaust pipe and 2 gaskets from the exhaust manifold LH.
7. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Disconnect the air fuel ratio sensor connector.
Disconnect the heated oxygen sensor connector and 2 clamps.
Remove the 3 nuts, front exhaust pipe and gasket from the exhaust manifold RH.
8. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
Using SST, remove the sensor.
- SST
- 09224-00010
9. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
Using SST, remove the sensor.
- SST
- 09224-00010
10. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
Using SST, remove the sensor.
- SST
- 09224-00010
11. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) |
Using SST, remove the sensor.
- SST
- 09224-00010