BRAKE SYSTEM > PRECAUTION

for Preparation Click here


NOTICE:
  1. Make sure to replace each part properly. Improper installation or repair could affect the performance of the brake system and cause a driving hazard.
  2. It is very important to keep the brake system parts and the work area clean when repairing the brake system.
  3. If the vehicle is equipped with a mobile communication system, refer to the Precautions in the INTRODUCTION section (Click here).
  4. Care must be taken when using magnets as they could affect the performance of the speed sensors.
  5. Since the brake line is one of the critical safety-related parts, be sure to disassemble the components if a brake fluid leak is found. If any abnormality is found, replace the component with a new one.
  6. When removing brake components, cover the brake tube connections to prevent foreign matter such as dust or dirt from entering the tubes.
  7. Do not damage or deform the brake tubes when removing or installing them.
  8. When installing a brake tube or flexible hose, ensure that it is not twisted or bent.
  9. If the fitting of the flexible hose does not match the groove on the bracket, twist the hose slightly to insert it.
  10. Flexible hoses must be free from absorber oil, grease, etc.
  11. When installing a brake tube to a plastic clamp, ensure that the brake tube is not loose or being pinched.
  12. Do not reuse a clip or plastic clamp removed from a flexible hose.
  13. After installing a brake tube and flexible hose, ensure that they do not interfere with any other components.
  14. Do not allow brake fluid to adhere to any painted surface such as the vehicle body. If brake fluid leaks onto any painted surface, immediately wash it off.

  15. C102779E10
    Follow these procedures when disconnecting the flexible hose and brake tube.
    1. Hold the flexible hose with a wrench. Using a union nut wrench, disconnect the brake tube without deforming the tube.
    2. Remove the clip.
  16. Follow these procedures when connecting the flexible hose and brake tube.
    1. Install a new clip.
    2. Hold the flexible hose with a wrench. Using a union nut wrench, connect the brake tube without deforming the tube.

  17. C155476
    Follow these procedures when connecting the brake tube and 2-way.
    1. Support the 2-way to prevent deformation to the brake tube and install the bolt to fix the 2-way to the body.
    2. Support the 2-way to prevent deformation to the brake tube and connect the brake tube to the 2-way with a union nut wrench.