OUTER REAR VIEW MIRROR > REMOVAL |
for Preparation Click here
- HINT:
- Use the same procedure for the LH side and RH side.
- The procedure listed below are for the LH side.
1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG |
Using a screwdriver, detach the 4 claws and remove the inside handle bezel.
- HINT:
- Tape the screwdriver tip before use.
2. REMOVE FRONT ARMREST UPPER BASE PANEL |
Using a screwdriver, detach the 2 clips and front upper armrest base panel.
- HINT:
- Tape the screwdriver tip before use.
Disconnect the connectors.
3. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) |
Insert a clip remover between the plate and trim.
Turn the handle clockwise to remove the handle.
4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH |
Detach the 3 clips and front lower door frame bracket garnish.
5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
Remove the 2 screws.
Using a clip remover, remove the clip.
Detach the 10 clips and remove the trim cover. Then disconnect the connector.
Disconnect the 2 cables from the inside handle.
Remove the inside handle.
6. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY |
w/ Power Mirror Control System:
Disconnect the connector labeled A.
Remove the 3 nuts.
Detach the claw and remove the outer rear view mirror.
7. REMOVE OUTER REAR VIEW MIRROR SUB-ASSEMBLY |
Push the upper part of the mirror surface and tilt it.
Using a moulding remover, push the bottom of the glass upwards as shown in the illustration. Slide the glass upwards to detach the 4 claws, and remove the glass.
- HINT:
- Apply protective tape to the outer rear view mirror to prevent it from being damaged.
w/ Mirror Heater:
Disconnect the 2 connectors and remove the mirror glass.
w/ Retract Mirror:
Disconnect the 3 connectors and remove the mirror glass.
8. REMOVE OUTER MIRROR LIGHT ASSEMBLY LH (for Standard) |
Disconnect the 2 connectors.
Detach the 2 claws and remove the light.
9. REMOVE OUTER MIRROR COVER (for Standard) |
Detach the 4 claws labeled A.
Slightly lift up the cover to detach the 3 claws labeled B and remove the outer mirror cover.
10. REMOVE SIDE TURN SIGNAL LIGHT LENS (for Extended Type) |
11. REMOVE OUTER MIRROR COVER LH (for Extended Type) |
Detach the 2 claws and remove the cover.