Tacoma

Toyota Tacoma 2015-2018 Clutch Workshop Manual

SST: 09301-00220
Torque:
19 N·m {195 kgf·cm, 14ft·lbf}
HINT:
Following the order in the illustration, tighten the bolts evenly one at a time.
Move SST up and down, and right and left lightly after checking that the clutch disc assembly is in the
center, and then tighten the bolts.
3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY
(a) Using a dial indicator with a roller instrument, check the
diaphragm spring tip alignment.
SST: 09333-00013
Maximum non-alignment:
0.5 mm (0.0196 in.)
If the alignment is more than the maximum, use SST to adjust
the diaphragm spring tip alignment.
4. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY
(a) Install the clutch release fork dust seal to the clutch release fork sub-assembly.
(b) Install the clutch release fork collar to the clutch release fork sub-assembly.
(c) Apply release hub grease to the clutch release fork sub-assembly, clutch release bearing assembly, push
rod contact point and pivot points shown in the illustration.
Text in Illustration
Release hub grease
Grease:
Toyota Genuine Release Hub Grease or equivalent
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *