Toyota Tacoma 2015-2018 Clutch Workshop Manual

(c) Using SST and a hammer, tap in a new input shaft bearing.
SST: 09304-30012
After installing the input shaft bearing to the crankshaft, make
sure that it rotates smoothly.
(d) Install 4 new bolts.
27 N·m {270 kgf·cm, 20ft·lbf}
The mounting bolts are tightened in 2 progressive steps.
(e) Mark the mounting bolts with paint.
Text in Illustration
*a Paint Mark
*b 9
(f) Retighten the mounting bolts by 90°.
(g) Check that the painted marks are now at a 90° angle to the original marked position.

Leave a Reply

Your email address will not be published. Required fields are marked *