Tacoma

Toyota Tacoma 2015-2018 Clutch Workshop Manual

(a) Using a dial indicator, measure the flywheel runout.
Maximum runout:
0.1 mm (0.00393 in.)
If the runout is more than the maximum, replace the flywheel
sub-assembly.
4. INSPECT CLUTCH RELEASE BEARING ASSEMBLY
(a) Check that the bearing turns smoothly by hand by applying force
in the axial direction.
If the bearing sticks or has a considerable amount of resistance,
replace the clutch release bearing assembly.
HINT:
The bearing is permanently lubricated and requires no cleaning
or lubrication.
5. INSPECT INPUT SHAFT BEARING
(a) Check that the bearing turns smoothly by hand by applying
rotational force.
If the bearing sticks or has a considerable amount of resistance,
replace the input shaft bearing.
HINT:
T
he bearing is permanently lubricated and requires no cleaning
or lubrication.
6. REPLACE INPUT SHAFT BEARING
(a) Remove any 4 diametrically opposite bolts.
(b) Using SST, remove the input shaft bearing.
SST: 09303-35011
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *