Tacoma

Toyota Tacoma 2015-2018 Clutch Workshop Manual

Last Modified: 11-13-2015 6.6 N Doc ID: RM0000010R706XX
Model Year Start: 2016 Model: Tacoma Prod Date Range: [08/2015 - ]
Title: CLUTCH: CLUTCH SYSTEM: BLEEDING; 2016 MY Tacoma [08/2015 - ]
BLEEDING
NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.
HINT:
I
f any work is performed on the clutch system or if there is thought to be air in the clutch lines, bleed air
from the clutch hydraulic system.
1. FILL RESERVOIR WITH BRAKE FLUID
(a) Fill the reservoir with brake fluid.
Brake fluid:
SAE J1703 or FMVSS No. 116 DOT 3
2. BLEED CLUTCH LINE
(a) Remove the bleeder plug cap of the release cylinder.
(b) Connect a vinyl tube to the bleeder plug.
(c) Depress the clutch pedal several times, and then loosen the bleeder plug while the pedal is depressed.
(d) When fluid no longer comes out, tighten the bleeder plug, and then release the clutch pedal.
(e) Repeat the previous 2 steps until all the air in the fluid is completely bled.
(f) Tighten the bleeder plug.
Torque:
11 N·m {110 kgf·cm, 8ft·lbf}
(g) Install the bleeder plug cap.
(h) Check that all the air has been bled from the clutch line.
3. CHECK FLUID LEVEL IN RESERVOIR
(a) Check the fluid level.
If the brake fluid level is low, check for leaks and inspect the disc brake pad. If necessary, refill the
reservoir with brake fluid after repair or replacement.
Brake fluid:
SAE J1703 or FMVSS No. 116 DOT 3
4. INSPECT FOR CLUTCH FLUID LEAK
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *