Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

DTC DETECTION
ITEM
DTC DETECTION
CONDITION
DTC DETECTION
PRE-CONDITION
DTC CHECK
PROCEDURE
WARNING
INDICATION
IN METER
DTC
STORAGE
METHOD
of the
blind
spot
monitor
sensor
LH is 10
V or
more.
U0126
Lost
Communication
with Steering
Angle Sensor
Module
The blind spot
monitor sensor
LH does not
receive data from
the spiral cable
with sensor
sub-assembly for
10.68 seconds or
more.
All conditions are
met:
Blind
spot
monitor
main
switch
on.
The
ignition
switch is
ON for 1
second
or more.
The
power
source
voltage
of the
blind
spot
monitor
sensor
LH is 10
V or
more.
Turn the
ignition switch
to ON, turn the
blind spot
monitor system
on using the
blind spot
monitor main
switch (ON/OFF
switch), wait at
least 11.68
seconds.
Displays
messages on
the multi-
information
display.
DTC is
stored until
it is cleared
using the
Techstream.
U0129
Lost
Communication
with Brake
System Control
Module
The blind spot
monitor sensor
LH does not
receive data from
the brake booster
assembly (skid
control ECU) or
brake actuator
assembly (skid
control ECU) for
2.334 seconds or
more.
All conditions are
met:
Blind
spot
monitor
main
switch
on.
The
ignition
switch is
ON for 1
Turn the
ignition switch
to ON, turn the
blind spot
monitor system
on using the
blind spot
monitor main
switch (ON/OFF
switch), wait at
least 4.334
seconds.
Displays
messages on
the multi-
information
display.
DTC is
stored until
it is cleared
using the
Techstream.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *