Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

DTC DETECTION
ITEM
DTC DETECTION
CONDITION
DTC DETECTION
PRE-CONDITION
DTC CHECK
PROCEDURE
WARNING
INDICATION
IN METER
DTC
STORAGE
METHOD
U0155
Lost
Communication
with
Combination
Meter
The clearance
warning ECU
assembly does
not receive data
from the
combination
meter assembly
for 5 seconds or
more.
Both conditions are
met:
The ignition
switch is ON
for 5
seconds or
more.
The power
source
voltage of
the
clearance
warning
ECU
assembly is
10.2 V or
more.
Turn the
ignition switch
to ON and
wait at least
10 seconds.
-
DTC is stored
until it is
cleared using
the
Techstream.
(o) Blind Spot Monitor Sensor LH / Techstream Display "Blind Spot Monitor Master"
HINT:
This ECU uses the CAN communication system for DTC communication.
*: Refer to Blind Spot Monitor System .
Blind Spot Monitor Sensor LH / Techstream Display "Blind Spot Monitor Master"
DTC DETECTION
ITEM
DTC DETECTION
CONDITION
DTC DETECTION
PRE-CONDITION
DTC CHECK
PROCEDURE
WARNING
INDICATION
IN METER
DTC
STORAGE
METHOD
U0100
Lost
Communication
with ECM / PCM
"A"
The blind spot
monitor sensor
LH does not
receive data from
the ECM for 10.84
seconds or more.
All conditions are
met:
Blind
spot
monitor
main
switch
on.
The
ignition
switch is
ON for 1
second
or more.
The
power
source
voltage
Turn the
ignition switch
to ON, turn the
blind spot
monitor system
on using the
blind spot
monitor main
switch (ON/OFF
switch), wait at
least 11.84
seconds.
Displays
messages on
the multi-
information
display.
DTC is
stored until
it is cleared
using the
Techstream.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *