Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

OK
*a
Front view of wire harness connector
(to Air Conditioning Amplifier Assembly)
NG
REPAIR OR REPLACE CAN BRANCH LINE OR
CONNECTOR (AIR CONDITIONING AMPLIFIER
ASSEMBLY)
3. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
(a) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER
CONNECTION
CONDITION SPECIFIED
CONDITION
A36-10 (GND) -
Body ground
Cable disconnected from
negative (-) battery terminal
Below 1 Ω
(b) Connect the cable to the negative (-) battery terminal.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
A36-1 (IG+) - Body ground Ignition switch ON 11 to 14 V
A36-17 (B) - Body ground Always 11 to 14 V
Text in Illustration
*a
Front view of wire harness connector
(to Air Conditioning Amplifier Assembly)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(POWER SOURCE CIRCUIT)
OK
REPLACE AIR CONDITIONING AMPLIFIER
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *