Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

DTC DETECTION
ITEM
DTC DETECTION
CONDITION
DTC DETECTION
PRE-CONDITION
DTC CHECK
PROCEDURE
WARNING
INDICATION
IN METER
DTC
STORAGE
METHOD
and 11.5 V.
U0151
Lost
Communication
with Restraints
Control Module
The combination
meter assembly
does not receive
data from the
airbag sensor
assembly for 10
seconds or
more.
Both conditions are met:
Ignition switch
is ON.
The power
source
voltage of the
combination
meter
assembly is
between 9.5
and 11.5 V.
Turn the
ignition
switch to ON
and wait at
least 10
seconds.
SRS warning
light
illuminates.
DTC is stored
until it is
cleared using
the
Techstream.
U0163
Lost
Communication
with Navigation
Control Module
The combination
meter assembly
does not receive
data from the
navigation
receiver
assembly or
radio and display
receiver
assembly for 10
seconds or
more.
Both conditions are met:
Ignition switch
is ON.
The power
source
voltage of the
combination
meter
assembly is
between 9.5
and 11.5 V.
Turn the
ignition
switch to ON
and wait at
least 10
seconds.
-
DTC is stored
until it is
cleared using
the
Techstream.
(k) Navigation Receiver Assembly / Techstream Display "Navigation System"
HINT:
T
his ECU uses the CAN communication system for DTC communication.
Navigation Receiver Assembly / Techstream Display "Navigation System"
DTC DETECTION
ITEM
DTC DETECTION
CONDITION
DTC DETECTION
PRE-CONDITION
DTC CHECK
PROCEDURE
WARNING
INDICATION
IN METER
DTC
STORAGE
METHOD
U0073
Sending
Malfunction
(Navigation to
APGS)
The navigation
receiver assembly
does not
send/receive data
10 times in
succession.
Both conditions are
met:
The ignition
switch is
ACC for 1
second or
more.
The power
source
voltage of
the
Turn the
ignition
switch to ACC
and wait at
least 11
seconds.
-
DTC is stored
until it is
cleared using
the
Techstream.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *