Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

DTC DETECTION
ITEM
DTC
DETECTION
CONDITION
DTC DETECTION
PRE-CONDITION
DTC CHECK
PROCEDURE
WARNING
INDICATION IN
METER
DTC
STORAGE
METHOD
the brake
booster
assembly
(skid
control
ECU)
(+BS
terminal
voltage)
is
between
9.6 and
16.5 V.
light check.
U0123
Lost
Communication
with Yaw Rate
Sensor Module
The brake
booster
assembly
(skid control
ECU) does not
receive data
from the
airbag sensor
assembly for
1.1 seconds
or more.
All conditions are
met:
Vehicle
speed is
6 km/h
(4 mph)
or more.
The
ignition
switch is
ON for 1
second or
more.
The
power
source
voltage of
the brake
booster
assembly
(skid
control
ECU)
(+BS
terminal
voltage)
is
between
9.6 and
16.5 V.
Turn the
ignition
switch to ON
and drive the
vehicle at a
speed of 6
km/ h (4
mph) or
more for 3
seconds or
more. Check
that the
warning light
remains off
after turning
off following
the initial
light check.
Slip indicator light
illuminates.
DTC is
stored until
it is cleared
using the
Techstream.
U0124
Lost
Communication
with Lateral
The brake
booster
assembly
All conditions are
met:
Vehicle
Turn the
ignition
switch to ON
Slip indicator light
illuminates.
DTC is
stored until
it is cleared
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *