Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

Text in Illustration
*a
Front view of wire harness connector
(to No. 2 CAN Junction Connector)
*b to No. 1 CAN Junction Connector
*c
to Door Control and Tire Pressure Monitoring System Receiver
Assembly (w/ Tire Pressure Warning System and Tire Inflation
Pressure Display Function)
*d to DLC3
*e to Main Body ECU (Multiplex Network Body ECU) *f
to Certification ECU (Smart Key ECU
Assembly) (w/ Smart Key System)
*g to Combination Meter Assembly *h
to Spiral Cable with Sensor
Sub-assembly
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER
CONNECTION
CONDITION SPECIFIED
CONDITION
CONNECTED TO
J3-1 (CANH) -
J3-11 (CANL)
Cable disconnected from
negative (-) battery terminal
108 to 132 Ω No. 1 CAN junction connector
J3-2 (CANH) -
J3-12 (CANL)
Cable disconnected from
negative (-) battery terminal
200 Ω or higher
Door control and tire pressure
monitoring system receiver
assembly*1
J3-3 (CANH) -
J3-13 (CANL)
Cable disconnected from
negative (-) battery terminal
1 MΩ or higher DLC3
J3-4 (CANH) -
J3-14 (CANL)
Cable disconnected from
negative (-) battery terminal
200 Ω or higher
Main body ECU (multiplex network
body ECU)
J3-5 (CANH) -
J3-15 (CANL)
Cable disconnected from
negative (-) battery terminal
200 Ω or higher
Certification ECU (smart key ECU
assembly)*2
J3-6 (CANH) -
J3-16 (CANL)
Cable disconnected from
negative (-) battery terminal
108 to 132 Ω Combination meter assembly
J3-7 (CANH) -
J3-17 (CANL)
Cable disconnected from
negative (-) battery terminal
108 to 132 Ω Spiral cable with sensor sub-assembly
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *