Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

(b) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER
CONNECTION
CONDITION SPECIFIED
CONDITION
F12-10 (GND) -
Body ground
Cable disconnected from
negative (-) battery terminal
Below 1 Ω
(c) Connect the cable to the negative (-) battery terminal.
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
F13-21 (+B) - Body ground Always 11 to 14 V
F12-4 (IG) - Body ground Ignition switch ON 11 to 14 V
Text in Illustration
*a
Front view of wire harness connector
(to 4 Wheel Drive Control ECU)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(POWER SOURCE CIRCUIT)
OK
REPLACE 4 WHEEL DRIVE CONTROL ECU
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *