Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

*e
to Navigation Receiver Assembly (for Navigation
Receiver Type) or Radio and Display Receiver
Assembly (for Radio and Display Type)
*f to ECM
*g
to Network Gateway ECU (w/ Blind Spot
Monitor System or Intuitive Parking Assist
System)
*h to Airbag Sensor Assembly
*i to 4 Wheel Drive Control ECU (for 4WD) - -
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER
CONNECTION
CONDITION SPECIFIED
CONDITION
CONNECTED TO
J16-1 (CANH) -
D4-4 (CG)
Cable disconnected from
negative (-) battery terminal
200 Ω or higher
Brake booster assembly (skid control
ECU)*1 or brake actuator assembly (skid
control ECU)*2
J16-11 (CANL) -
D4-4 (CG)
J16-2 (CANH) -
D4-4 (CG)
Cable disconnected from
negative (-) battery terminal
200 Ω or higher No. 2 CAN junction connector
J16-12 (CANL) -
D4-4 (CG)
J16-3 (CANH) -
D4-4 (CG)
Cable disconnected from
negative (-) battery terminal
200 Ω or higher Air conditioning amplifier assembly
J16-13 (CANL) -
D4-4 (CG)
J16-4 (CANH) -
D4-4 (CG)
Cable disconnected from
negative (-) battery terminal
200 Ω or higher
Navigation receiver assembly*3 or radio
and display receiver assembly*4
J16-14 (CANL) -
D4-4 (CG)
J16-5 (CANH) -
D4-4 (CG)
Cable disconnected from
negative (-) battery terminal
200 Ω or higher ECM
J16-15 (CANL) -
D4-4 (CG)
J16-6 (CANH) -
D4-4 (CG)
Cable disconnected from
negative (-) battery terminal
200 Ω or higher Network gateway ECU*5
J16-16 (CANL) -
D4-4 (CG)
J16-7 (CANH) -
D4-4 (CG)
Cable disconnected from
negative (-) battery terminal
200 Ω or higher Airbag sensor assembly
J16-17 (CANL) -
D4-4 (CG)
J16-8 (CANH) -
D4-4 (CG)
Cable disconnected from
negative (-) battery terminal
200 Ω or higher 4 wheel drive control ECU*6
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *