Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

A
PROCEDURE
1. RECONFIRM DTC OUTPUT
(a) Reconfirm DTCs.
HINT:
If DTC U1002 is output from Gateway of the network gateway ECU, this indicates a sub bus 2 malfunction.
Troubleshoot for DTC U1002 and check for malfunctions in sub bus 2.
RESULT P
ROCEED TO
U1002 is not output from network gateway ECU.
(Techstream display: Gateway)
A
U1002 is output from network gateway ECU.
(Techstream display: Gateway)
B
B
GO TO DIAGNOSIS PROCEDURE INDICATED BY
OUTPUT DTC
2.
C
HECK FOR OPEN IN CAN BUS LINES (BLIND SPOT MONITOR SENSOR LH BRANCH
LINE)
(a) Disconnect the cable from the negative (-) battery terminal.
(b) Disconnect the blind spot monitor sensor LH connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
B12-2 (CA1P) - B12-7 (CA1N) Cable disconnected from negative (-) battery terminal 54 to 69 Ω
Text in Illustration
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *