Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

OK
PROCEDURE
1.
CHECK FOR OPEN IN CAN BUS LINES (DOOR CONTROL AND TIRE PRESSURE
MONITORING SYSTEM RECEIVER ASSEMBLY BRANCH LINE)
(a) Disconnect the cable from the negative (-) battery terminal.
(b) Disconnect the door control and tire pressure monitoring
system receiver assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
T24-9 (CANH) - T24-10 (CANL) Cable disconnected from negative (-) battery terminal 54 to 69 Ω
Text in Illustration
*a
Front view of wire harness connector
(to Door Control and Tire Pressure Monitoring System Receiver Assembly)
NG
REPAIR OR REPLACE CAN BRANCH LINE OR
CONNECTOR (DOOR CONTROL AND TIRE
PRESSURE MONITORING SYSTEM RECEIVER
ASSEMBLY)
2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *