Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

(a) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER
CONNECTION
CONDITION SPECIFIED
CONDITION
S32-1 (ESS) -
Body ground
Cable disconnected from
negative (-) battery terminal
Below 1 Ω
(b) Connect the cable to the negative (-) battery terminal.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
S32-4 (IG) - Body ground Ignition switch ON 11 to 14 V
S32-5 (BAT) - Body ground Always 11 to 14 V
Text in Illustration
*a
Front view of wire harness connector
(to Spiral Cable with Sensor Sub-assembly)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(POWER SOURCE CIRCUIT)
OK
REPLACE SPIRAL CABLE WITH SENSOR
SUB-ASSEMBLY
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *