Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

2.
CHECK FOR OPEN IN CAN BUS LINES (COMBINATION METER ASSEMBLY - NO. 2 CAN
JUNCTION CONNECTOR)
(a) Disconnect the combination meter assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
C9-1 (CANH) - C9-2 (CANL) Cable disconnected from negative (-) battery terminal 108 to 132 Ω
Text in Illustration
*a
Front view of wire harness connector
(to Combination Meter Assembly)
NG
GO TO STEP 3
OK
REPLACE COMBINATION METER ASSEMBLY
3. CHECK FOR OPEN IN CAN BUS LINES (ECM - NO. 1 CAN JUNCTION CONNECTOR)
(a) for 2GR-FKS
(1) Reconnect the C9 combination meter assembly connector.
(2) Disconnect the ECM connector.
(3) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *