Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

4. CHECK HARNESS AND CONNECTOR (GND1 CIRCUIT)
(a) Disconnect the driver side junction block connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
1D-5 - Body ground Always Below 1 Ω
Text in Illustration
*a
Front view of wire harness connector
(to Driver Side Junction Block)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(GND1 CIRCUIT)
OK
REPLACE DRIVER SIDE JUNCTION BLOCK
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *