Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

(a) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER
CONNECTION
CONDITION SPECIFIED
VALUE
N32-4 (GND) - Body
ground
Cable disconnected from
negative (-) battery terminal
Below 1 Ω
(b) Connect the cable to the negative (-) battery terminal.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION SWITCH CONDITION SPECIFIED VALUE
N32-2 (BATT) - Body ground Always 11 to 14 V
N32-9 (IG2) - Body ground Ignition switch ON 11 to 14 V
N32-10 (IG1) - Body ground Ignition switch ON 11 to 14 V
Text in Illustration
*a
Front view of wire harness connector
(to Network Gateway ECU)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(POWER SOURCE CIRCUIT)
OK
REPLACE NETWORK GATEWAY ECU
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *