Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

TESTER DISPLAY MEASUREMENT ITEM/RANGE NORMAL CONDITION DIAGNOSTIC NOTE
Right Side Buckle SW
RH Side Buckle SW/
Unset: The seat belt is not fastened
Set: The seat belt is fastened
NG: Data is not determined
Unset/Set -
*: w/ Occupant Classification System
(o) Details of relevant Data List items (Selected system: Tire Pressure Monitor)
HINT:
U
sing the Techstream to read the Data List allows the values or states of switches, sensors, actuators and
other items to be read without removing any parts. This non-intrusive inspection can be very useful because
intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data
List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on
these reference values when deciding whether a part is faulty or not.
(1) Turn the ignition switch off.
(2) Connect the Techstream to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the Techstream on.
(5) Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
(6) According to the display on the Techstream, read the Data List.
Tire Pressure Monitor
TESTER
DISPLAY
MEASUREMENT ITEM/RANGE NORMAL
CONDITION
DIAGNOSTIC NOTE
Vehicle Speed
Vehicle speed reading/
min.: 0 km/h (0 mph), max.: 255
km/h (158 mph)
Actual vehicle
speed
Speed indicated on the combination
meter assembly
(p) Details of relevant Data List items (Selected system: Four Wheel Drive)
NOTICE:
I
n the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on
these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and
other items to be read without removing any parts. This non-intrusive inspection can be very useful because
intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data
List information early in troubleshooting is one way to save diagnostic time.
(1) Turn the ignition switch off.
(
2) Connect the Techstream to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the Techstream on.
(5) Enter the following menus: Powertrain / Four Wheel Drive / Data List.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *