Tacoma

Toyota Tacoma 2015-2018 CAN Workshop Manual

OK
PROCEDURE
1. CHECK FOR OPEN IN CAN BUS LINES (AIRBAG SENSOR ASSEMBLY BRANCH LINE)
(a) Disconnect the cable from the negative (-) battery terminal.
(b) Disconnect the airbag sensor assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED
CONDITION
A21-13 (CANH) - A21-22
(CANL)
Cable disconnected from negative (-) battery
terminal
54 to 69 Ω
Text in Illustration
*a
Front view of wire harness connector
(to Airbag Sensor Assembly)
NG
REPAIR OR REPLACE CAN BRANCH LINE OR
CONNECTOR (AIRBAG SENSOR ASSEMBLY)
2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *