Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
OK
Text in Illustration
*a
Front view of wire harness connector
(to Skid Control ECU (Master Cylinder Solenoid))
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
8. CHECK HARNESS AND CONNECTOR (GND TERMINAL)
(a) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S1-1 (GND1) - Body ground Always Below 1 Ω
S1-32 (GND2) - Body ground Always Below 1 Ω
S2-4 (GND3) - Body ground Always Below 1 Ω
Text in Illustration
*a
Front view of wire harness connector
(to Skid Control ECU (Master Cylinder Solenoid))
(b) Reconnect the skid control ECU (master cylinder solenoid) connector.
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
9. INSPECT BRAKE FLUID LEVEL WARNING SWITCH
(a) Disconnect the B2 brake fluid level warning switch (brake master cylinder reservoir sub-assembly)
connector.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *