Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
A
NOTICE:
When replacing the skid control ECU (master cylinder solenoid), perform calibration .
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. CHECK THAT SKID CONTROL ECU CONNECTOR SECURELY CONNECTED
(a) Check the skid control ECU (master cylinder solenoid) connector connection.
OK:
The connector is securely connected.
NG
CONNECT CONNECTOR TO ECU CORRECTLY
2. CHECK DTC
(a) Check for DTCs .
Result
RESULT PROCEED TO
DTC is not output A
DTC is output B
B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
3. INSPECT BATTERY
(a) Inspect the battery voltage .
Standard voltage:
11 to 14 V
NG
CHECK CHARGING SYSTEM
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *