Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
5. PERFORM ACTIVE TEST USING TECHSTREAM (AUTO LSD INDICATOR LIGHT)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
(e) According to the display on the Techstream, perform the Active Test.
ABS/VSC/TRAC
TESTER DISPLAY TEST PART CONTROL RANGE DIAGNOSTIC NOTE
Auto LSD Indicator Light Auto LSD indicator light Indicator light OFF/ON
Observe the combination meter.
[Vehicle condition]
Vehicle stopped
(f) When performing the ABS Warning Light Active Test, check ABS Warning Light in the Data List.
ABS/VSC/TRAC
TESTER DISPLAY MEASUREMENT ITEM/RANGE NORMAL CONDITION DIAGNOSTIC NOTE
Auto LSD Indicator Light Auto LSD indicator light/ ON or OFF
ON: Indicator light on
OFF: Indicator light off
-
Result
RESULT PROCEED TO
Auto LSD Indicator Light in the Data List does not change using the Active Test A
Auto LSD Indicator Light in the Data List turns ON/OFF using the Active Test B
NG
REPLACE MASTER CYLINDER SOLENOID
OK
GO TO METER / GAUGE SYSTEM (HOW TO
PROCEED WITH TROUBLESHOOTING)
6.
INSPECT VSC OFF SWITCH
NG
REPLACE VSC OFF SWITCH
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *