Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

Last Modified: 11-13-2015 6.6 A Doc ID: RM000003N5Z007X
Model Year Start: 2016 Model: Tacoma Prod Date Range: [08/2015 - ]
Title: BRAKE: BRAKE FLUID (for Hydraulic Brake Booster): REPLACEMENT; 2016 MY Tacoma [08/2015 - ]
REPLACEMENT
NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.
Depressing the brake pedal with the reservoir cap removed will cause the fluid to spray.
HINT:
If any work is done on the brake system or if air in the brake lines is suspected, bleed the air from the
system.
When bleeding, maintain the amount of fluid in the reservoir between the Min. and Max. lines.
1. FILL RESERVOIR WITH BRAKE FLUID
Fluid:
SAE J1703 or FMVSS NO. 116 DOT3
2. BLEED BRAKE BOOSTER WITH ACCUMULATOR PUMP ASSEMBLY
HINT:
If the brake master cylinder is disassembled, the brake line is disconnected from the brake master cylinder
or if the reservoir becomes empty, bleed the brake master cylinder.
(a) Turn the ignition switch to ON, and wait until the pump motor has stopped (step A).
HINT:
Pump operating sound can be heard.
(b) Turn the ignition switch to OFF, and depress the
brake pedal more than 20 times (step B).
HINT:
When pressure in the accumulator is released, the reaction force becomes lighter and the stroke becomes
longer.
(c) Repeat step A and B 5 times (step C).
(d) Turn the ignition switch to ON, and check that the pump stops after approximately 8 to 14 seconds.
NOTICE:
If the pump does not stop, repeat step C again.
3. BLEED BRAKE LINE
(a) Turn the ignition switch to ON, and wait until the pump motor has stopped.
HINT:
Pump operating sound can be heard.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *