Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

(a) Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.
SST: 09718-00010
(b) Using needle-nose pliers, disconnect the parking brake cable No.
3 and remove the rear brake shoe.
(c) Using a screwdriver, remove the 2 C-washers, parking brake
shoe lever, parking brake reaction lever and parking brake shoe
strut set.
3. REMOVE FRONT OR UPPER REAR WHEEL BRAKE
CYLINDER ASSEMBLY
(a) Using a union nut wrench, disconnect the brake tube, and use a
container to collect the brake fluid as it flows out.
(b) Remove the 2 bolts and rear wheel brake cylinder assembly.
4. REMOVE REAR WHEEL CYLINDER CUP KIT
(a) Remove the 2 wheel cylinder boots from the rear wheel brake cylinder.
(b) Remove the 2 pistons and compression spring.
(c) Remove the 2 cylinder cups from each piston.
(d) Remove the bleeder plug cap and bleeder plug from the rear wheel brake cylinder.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *