Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

10. INSTALL BRAKE ACTUATOR HOSE NO.1
(a) Using needle-nose pliers, install the brake actuator hose and 2
clips.
11. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
(a) Install the cap.
(b) Apply lithium soap base glycol grease to the 3 new grommets.
(c) Install the 3 grommets to the master cylinder body.
NOTICE:
Be careful of the size of each grommets.
(d) Install the master cylinder reservoir.
(e) Using a pin punch and hammer, install a new pin onto the
master cylinder reservoir.
(f) Install the screw onto the master cylinder reservoir.
Torque:
1.7 N·m {17 kgf·cm, 15in·lbf}
12. INSTALL BRAKE ACTUATOR BRACKET NO. 1
(a) Install the fluid level warning switch connector.
(b) Using a hexagon wrench (5 mm), install the brake actuator
bracket No. 1 with the screw.
Torque:
7.8 N·m {80 kgf·cm, 69in·lbf}
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *