Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

8. REMOVE MASTER CYLINDER PUSH ROD CLEVIS
(a) Loosen the lock nut on the brake master cylinder side, and then remove the rod operating adapter and
lock nut.
(b) Loosen the lock nut on the rod operating adapter, and then remove the push rod clevis and lock nut.
9. REMOVE MASTER CYLINDER BOOT
10. REMOVE PISTON
(a) Which pressing in the piston with a screwdriver, use a pin or
equivalent to push the C-ring from the hole in the master
cylinder body. Then remove the snap ring with another
screwdriver.
(b) Remove the piston by pulling it straight out, not at an angle.
NOTICE:
I
f the piston is pulled out at an angle, there is a possibility that
the cylinder bore could be damaged.
Be careful not to damage the rubber lips on the piston when
reassembling.
11. REMOVE MASTER CYLINDER SOLENOID
(a) Remove the 6 bolts.
(b) Remove the master cylinder solenoid and the gasket.
12. REMOVE BRAKE BOOSTER ACCUMULATOR ASSEMBLY
(a) Place the brake booster with accumulator pump assembly in a
vise with a cloth.
(b) Using a socket wrench (17 mm), remove the brake booster
accumulator.
(c) Remove the brake booster accumulator pipe, compression spring
and O-ring.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *