Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

Last Modified: 11-13-2015 6.6 A Doc ID: RM00000171H00JX
Model Year Start: 2016 Model: Tacoma Prod Date Range: [08/2015 - ]
Title: BRAKE: FRONT BRAKE: REMOVAL; 2016 MY Tacoma [08/2015 - ]
REMOVAL
HINT:
Use the same procedure for the LH side and RH side.
The following procedure listed is for the LH side.
1. REMOVE FRONT WHEEL
2. DRAIN BRAKE FLUID
NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.
3. REMOVE FRONT DISC BRAKE ANTI-RATTLE WITH HOLE PIN
(a) for Pin Hold Clip Type A:
(1) Remove the pin hold clip from the 2 front disc brake
anti-rattle with hole pins.
Text in Illustration
*1 Front Disc Brake Anti-rattle with Hole Pin
*2 Pin Hold Clip
*3 Anti-rattle Spring
NOTICE:
T
he pin hold clip can be used again if it has sufficient rebound;
no deformation or wear; and has had all rust, dirt and foreign
matter cleaned off.
(2) Remove the 2 front disc brake anti-rattle with hole pins from
the disc brake cylinder assembly.
(3) Remove the anti-rattle spring from the front disc brake pad.
NOTICE:
The anti-rattle spring can be used again if it has sufficient
rebound; no deformation, cracks or wear; and has had all rust,
dirt and foreign matter cleaned off.
(b) for Pin Hold Clip Type B:
(1) Remove the 2 pin hold clips from the 2 front disc brake
anti-rattle with hole pins.
Text in Illustration
*1 Front Disc Brake Anti-rattle with Hole Pin
*2 Pin Hold Clip
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *