Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

NOTICE:
If necessary, replace the anti-squeal shim kit when replacing the brake pad.
5. INSTALL FRONT DISC BRAKE PAD KIT
(a) Install the 2 front disc brake pads with front anti-squeal shim onto the disc brake cylinder assembly.
NOTICE:
There should be no oil or grease on the friction surfaces of the brake pads and the front disc.
6. INSTALL FRONT DISC BRAKE ANTI-RATTLE WITH HOLE PIN
(a) for Pin Hold Clip Type A:
(1) Install the anti-rattle spring to the front disc brake pad.
NOTICE:
T
he anti-rattle spring can be used again if it has sufficient rebound; no deformation, cracks or wear; and
has had all rust, dirt and foreign matter cleaned off.
(2) Install the 2 front disc brake anti-rattle with hole pins to the disc brake cylinder assembly.
(3) Install the pin hold clip to the 2 front disc brake anti-rattle with hole pins.
NOTICE:
The pin hold clip can be used again if it has sufficient rebound; no deformation or wear; and has had all
rust, dirt and foreign matter cleaned off.
(b) for Pin Hold Clip Type B:
(1) Install the anti-rattle spring to the front disc brake pad.
NOTICE:
The anti-rattle spring can be used again if it has sufficient rebound; no deformation, cracks or wear; and
has had all rust, dirt and foreign matter cleaned off.
(2) Install the 2 front disc brake anti-rattle with
hole pins to the disc brake cylinder assembly.
(3) Install 2 new pin hold clips to the 2 front disc brake
anti-rattle with hole pins.
Text in Illustration
*a Handle
NOTICE:
Be sure to install the pin hold clip with the handle facing to the
vehicle center.
7. FILL RESERVOIR WITH BRAKE FLUID (for Hydraulic Brake Booster)
8. FILL RESERVOIR WITH BRAKE FLUID (for Vacuum Brake Booster)
9. BLEED BRAKE BOOSTER WITH ACCUMULATOR PUMP ASSEMBLY (for Hydraulic Brake
Booster)
10. BLEED MASTER CYLINDER (for Vacuum Brake Booster)
11. BLEED BRAKE LINE (for Hydraulic Brake Booster)
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *