Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

Last Modified: 11-13-2015 6.6 J Doc ID: RM000005VAM000X
Model Year Start: 2016 Model: Tacoma Prod Date Range: [08/2015 - ]
Title: BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster): TS and CG
Terminal Circuit; 2016 MY Tacoma [08/2015 - ]
TS and CG Terminal Circuit
DESCRIPTION
In Test Mode (signal check), a malfunction in the speed sensor that cannot be detected when the vehicle is
stopped can be detected while driving.
Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the ignition
switch from off to ON.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store
system information .
PROCEDURE
1. CHECK HARNESS AND CONNECTOR (BRAKE ACTUATOR ASSEMB
LY - TS of DLC3)
(a) Turn the ignition switch off.
(b) Disconnect the S1 skid control ECU (brake actuator assembly) connector.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *