Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

Last Modified: 11-13-2015 6.6 A Doc ID: RM000000SS60AHX
Model Year Start: 2016 Model: Tacoma Prod Date Range: [08/2015 - ]
Title: BRAKE CONTROL: STEERING ANGLE SENSOR: INSTALLATION; 2016 MY Tacoma [08/2015 - ]
INSTALLATION
1. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) terminal is disconnected.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent
airbag and seat belt pretensioner activation.
(c) Confirm that the front tires face straight forward.
(d) Engage the 3 claws and install the spiral cable sub-assembly with sensor.
NOTICE:
When replacing the spiral cable sub-assembly with sensor with a new one, remove the lock pin before
installing the steering wheel.
(e) Connect the connectors to the spiral cable sub-a
ssembly with sensor.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
2. REMOVE UPPER STEERING COLUMN COVER
3. INSTALL LOWER STEERING COLUMN COVER
4. ADJUST SPIRAL CABLE
(a) Rotate the spiral cable sub-assembly with sensor counterclockwise slowly by hand until it feels firm.
NOTICE:
Do not turn the spiral cable sub-assembly with sensor by the airbag wire harness.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *