Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

(a) Turn the ignition switch off.
(b) Replace the ECM.
for 2GR-FKS:
for 2TR-FE:
(c) Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
SST: 09843-18040
(d) Check that the ABS warning and slip indicator lights are blinking.
OK:
The ABS warning and slip indicator lights are blinking.
Text in Illustration
*a Front view of DLC3
NG
REPLACE BRAKE ACTUATOR ASSEMBLY
OK
END
4. CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)
(a) Turn the ignition switch off.
(b) Disconnect the E13*1, E21*2 ECM connector.
*1: for 2GR-FKS
*2: for 2TR-FE
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for 2GR-FKS:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
D4-13 (TC) - E14-20 (TC) Always Below 1 Ω
D4-13 (TC) or E14-20 (TC) - Body ground Always 10 kΩ or higher
for 2TR-FE:
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *