Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(GND1 CIRCUIT)
6. READ VALUE USING TECHSTREAM (SLIP INDICATOR LIGHT)
(a) Reconnect the S1 skid control ECU (brake actuator assembly) connector.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
(f) According to the display on the Techstream, read the Data List.
ABS/VSC/TRAC
TESTER DISPLAY MEASUREMENT ITEM RANGE NORMAL CONDITION DIAGNOSTIC NOTE
Slip Indicator Light SLIP indicator light OFF or ON
OFF: Indicator light off
ON: Indicator light on
-
(g) Check the Techstream display condition of the slip indicator light.
Result
RESULT PROCEED TO
Display of the Data List remains OFF A
Display of the Data List remains ON B
B
REPLACE BRAKE ACTUATOR ASSEMBLY
A
INSPECT METER / GAUGE SYSTEM
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *