Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
*a
Front view of wire harness connector
(to Steering Angle Sensor [Spiral Cable with Sensor
Sub-assembly])
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(IG CIRCUIT)
4. CHECK HARNESS AND CONNECTOR (ESS TERMINAL)
(a) Turn the ignition switch off.
(b) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S32-1 (ESS) - Body ground Always Below 1 Ω
Text in Illustration
*a
Front view of wire harness connector
(to Steering Angle Sensor [Spiral Cable with Sensor
Sub-assembly])
HINT:
I
f troubleshooting has been carried out according to the Problem
Symptoms Table, refer back to the table and proceed to the next
step
.
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(ESS CIRCUIT)
OK
REPLACE SPIRAL CABLE WITH SENSOR
SUB-ASSEMBLY
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *