Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
(b) Remove the steering wheel and the column cover lower .
(c) Make sure that there is no looseness at the locking part and
the connecting part of the connectors.
(d) Disconnect the S32 steering angle sensor (spiral cable with sensor sub-assembly) connector.
(e) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
S32-5 (BAT) - Body ground Always 11 to 14 V
Text in Illustration
*a
Front view of wire harness connector
(to Steering Angle Sensor [Spiral Cable with Sensor Sub-assembly])
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(BAT CIRCUIT)
3. CHECK TERMINAL VOLTAGE (IG TERMINAL)
(a) Turn the ignition switch to ON.
(b) Measure the voltage according to the value(s) in the table
below.
Standard Voltage:
TESTER CONNECTION SWITCH
CONDITION
SPECIFIED
CONDITION
S32-4 (IG) - Body
ground
Ignition switch ON 11 to 14 V
Text in Illustration
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *