Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
OK
2. CHECK TERMINAL VOLTAGE (IG TERMINAL)
(a) Turn the ignition switch to ON.
(b) Measure the voltage according to the value(s) in the table
below.
Standard Voltage:
TESTER CONNECTION SWITCH
CONDITION
SPECIFIED
CONDITION
S32-4 (IG) - Body
ground
Ignition switch ON 11 to 14 V
Text in Illustration
*a
Front view of wire harness connector
(to Steering Angle Sensor [Spiral Cable with Sensor
Sub-assembly])
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(IG CIRCUIT)
3. CHECK HARNESS AND CONNECTOR (ESS TERMINAL)
(a) Turn the ignition switch off.
(b) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S32-1 (ESS) - Body ground Always Below 1 Ω
Text in Illustration
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *