Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

HINT:
DTC will be output when conditions for either of the patterns in the table above are met.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store
system information .
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
HINT:
When C1241 and/or C1417 is output together with C142B, C146C and/or C146D inspect and repair the
trouble areas indicated by C1241 and/or C1417 first.
for C1241:
for C1417:
PROCEDURE
1. CHECK TERMINAL VOLTAGE (BM TERMINAL)
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *