Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
OK
NG
GO TO STEP 8
4. RECONFIRM DTC
(
a) Turn the ignition switch off.
(b) Clear the DTCs
.
(c) Start the engine.
(d) Depress the brake pedal several times to test the stop light circuit.
(e) Check if the same DTC is recorded .
Result
RESULT PROCEED TO
DTC C1426 is not output. A
DTC C1426 is output. B
HINT:
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and
proceed to the next step .
B
REPLACE BRAKE ACTUATOR ASSEMBLY
A
USE SIMULATION METHOD TO CHECK
5. INSPECT STOP LIGHT SWITCH ASSEMBLY
(a) Check the stop light switch assembly .
OK:
The stop light switch assembly is normal.
NG
REPLACE STOP LIGHT SWITCH ASSEMBLY
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *