Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
OK
assembly, this DTC may be stored. Therefore, be sure to check the installation condition of the pedal and
switch before inspecting the input signals and other related parts.
NG
ADJUST BRAKE PEDAL OR STOP LIGHT SWITCH
ASSEMBLY
2. CHECK STOP LIGHT OPERATION
(a) Check that all stop lights come on when the brake pedal is depressed, and go off when the brake
pedal is released.
OK:
CONDITION ILLUMINATION CONDITION
Brake pedal depressed. On
Brake pedal released. Off
NG
GO TO STEP 5
3. READ VALUE USING TECHSTREAM (STOP LIGHT SWITCH ASS
EMBLY)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Select the Data List using the Techstream
.
ABS/VSC/TRAC
TESTER DISPLAY MEASUREMENT ITEM RANGE NORMAL CONDITION DIAGNOSTIC NOTE
Stop Light SW Stop light switch ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
(d) Check that the stop light switch display observed on the Techstream changes according to brake
pedal operation.
OK:
The Techstream displays ON or OFF according to brake pedal operation.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *