Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
OK
2. CHECK HARNESS AND CONNECTOR (STP TERMINAL)
(a) Turn the ignition switch off.
(b) Make sure that there is no looseness at the locking part and the connecting part of the connectors.
(c) Disconnect the S1 skid control ECU (brake actuator assembly) connector.
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
S1-35 (STP) - Body ground
Stop light switch assembly on (Brake pedal depressed) 8 to 14 V
Stop light switch assembly off (Brake pedal released) Below 1.5 V
Text in Illustration
*a
Front view of wire harness connector
(to Skid Control ECU [Brake Actuator Assembly])
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(BRAKE ACTUATOR ASSEMBLY - STOP LIGHT
CIRCUIT)
3. RECONFIRM DTC
(a) Reconnect the S1 skid control ECU (brake actuator assembly) connector.
(b) Clear the DTCs .
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *