Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
OK
5. CHECK BRAKE PEDAL AND STOP LIGHT SWITCH ASSEMBLY INSTALLATION
(a) Turn the ignition switch off.
(b) Check the brake pedal height and stop light switch assembly installation .
OK:
The brake pedal height and stop light switch assembly installation are normal.
NG
ADJUST BRAKE PEDAL OR STOP LIGHT SWITCH
ASSEMBLY
6. INSPECT STOP LIGHT SWITCH ASSEMBLY
(a) Remove the stop light switch assembly .
(b) Inspect the stop light switch assembly .
OK:
The stop light switch assembly is normal.
NG
REPLACE STOP LIGHT SWITCH ASSEMBLY
7. CHECK HARNESS AND CONNECTOR (STP TERMINAL)
(a) Turn the ignition switch off.
(b) Make sure that there is no looseness at the locking part and the connecting part of the connector.
(c) Disconnect the skid control ECU (brake actuator assembly) connector.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *