Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
INSPECTION PROCEDURE
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store
system information .
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. INSPECT BATTERY
(
a) Check the battery voltage.
Standard voltage:
11 to 14 V
NG
CHECK OR REPLACE CHARGING SYSTEM OR
BATTERY
2. CHECK TERMINAL VOLTAGE (+BS, GND1 TERMINAL)
(a) Turn the ignition switch off.
(b) Make sure that there is no looseness at the locking part and the connecting part of the connectors.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *